Cm2250 overhead question

[marek4792]

(04-19-2021 )jimeneztrans84 Wrote:  I think I'm doing this wrong. When it's A6 is it the last cylinder? 123456 just like I was changing a injector?

yes
A is cylinder 1
B is 5
C is 3
then when you bar the engine again
A is 6
B is 2
C is 4

if both 3 and 4 exhaust rockers are loose at C someone screwed up the adjustment or (possible mechanical issue) because lets say you start at A which is 1 and 6 only one of those cylinders the rockers should be loose and on the opposite cylinder all the rockers should be tight.. The loose rockers are the ones you are adjusting.. So if you did 6 first then you go 2 and 4 and then 153..