Main, rod bearing and oil pump

[jimeneztrans84]

(09-07-2016 )Hammerhead Wrote:  

(09-07-2016 )Mr Hagg Wrote:  No but a sticking pressure valve would. Its built in the pump

Perhaps a score in the pressure regulating bore when performing the pump shim procedure Mr Hagg?
I watched Rawze's video of the oil pump shim procedure, the only thing I did different was I placed the dimes in the cup of the dogbone so they were "captured". I don't believe it should make a difference, but is there any possibility that if the dimes are on the ball end of the spring instead that they may flutter during startup and catch on something until sufficient pressure (80psi) forces them into alignment? Just spitballing

I'm getting ready to shim my pump next oil change. Do I do pUT the dimes between spring and dog bone or like rawze did on the video? I think it might be pretty hard to do like rawze with pump installed and being able to keep dimes straight no?