Main, rod bearing and oil pump

[Hammerhead]

(09-09-2016 )jimeneztrans84 Wrote:  I'm getting ready to shim my pump next oil change. Do I do pUT the dimes between spring and dog bone or like rawze did on the video? I think it might be pretty hard to do like rawze with pump installed and being able to keep dimes straight no?

That's entirely up to you. I think either way will work fine.
Personally I put mine in the dogbone cup.
My reasoning was;
By placing the dime pack in the cup, the spring stays aligned against the pump body and poses no disruption of oil flow into the regulating bore as the spring end is still open and unobstructed. The dimes are "captured" and pose no risk without a spring failure. The dime pack is short enough that the end of the spring is "centered" because it still inserts into the cup still held in place by the cup wall thereby protecting the bore surface as much as possible.
Also, IF I decided I wasn't satisfied, suspected issues, or I wanted to add more because I was conservative and only used 7, I thought it would be quite simple to remove or add to the dime pack as they will probably stay stuck in the dogbone by the surface tension of the oil.
BTW, I'm also full of $#!t, and you do this procedure at your own risk...but I'm pleased with the results.