ISX CM2250 in a Freightshaker

[Ironwagons]

      

(04-13-2023 )Rawze Wrote:  

(04-13-2023 )Ironwagons Wrote:  Has anyone found or used aftermarket high pressure fuel system sealing washers for the banjo fittings? I can’t believe I got quoted over 65 dollars for 3 washers. Is this normal?

I don't think any of the actual banjo fittings (a hollow bolt with flat washers on both sides of them) have to suffer the 40,000 psi pressures. I think they are all on the low pressure side of the system if I am not mistaken.

maybe a pic or 2 of the fittings you are referring to?.

Yes, I am sure you are correct Rawze now you mentioned and I thought about it. It is the mess of lines that go through the ecm cooling plate etc prior to the high pressure pump. I put some yellow arrows to the fittings I am looking for the sealing washers from.
I was looking around and saw these attached pict…I can buy the whole damn box for the cost of 1 oem washer.