Error 5081
12-13-2024, (Subject: Error 5081 ) 
Post: #7
RE: Error 5081
(12-12-2024 )Kolczyk Wrote:  Hi. I have this message on Insite " Insite has detected some ECM have an invalid Footprint and must be recalibrated." Can somebody tell me how to do it?

Probably a corrupt file in the ecm.

re-flash the ecm with the latest factory file according to the ser# on the engine.

and ... If you got the ecm form somewhere besides a certified OEM stealers$it then you did nothing but wasted your moneys.

What you did was jumped over a dollar to save 10 cents.

You should have purchased an OEM certified ecm from the vehicle stealers$it and also had them pre-flash it with the correct software + all the correct truck settings for your VIN#, etc. - This guarantees that you have a good ecm and proper programming. OEM certified ecms have brand new circuit board in them as well, instead of some ancient trash that is worn out/flaky, etc... this even if it is a reman unit.

sounds a bit harsh, but for a $2,000+ item and big towing bills when it leaves you on the side of the road, maybe is flaky, etc... and when it fails prematurely again (because repaired units always do) = wasted time and moneys. I.E.> You don't take no chances, to avoid all the headaches that cost more than if you got a certified one to begin with.


User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!.
replyreply


Messages In This Thread
Error 5081 - Kolczyk - 12-12-2024,
RE: Error 5081 - tree98 - 12-13-2024,
RE: Error 5081 - Kolczyk - 12-13-2024,
RE: Error 5081 - tree98 - 12-13-2024,
RE: Error 5081 - Kolczyk - 12-13-2024,
RE: Error 5081 - tree98 - 12-13-2024,
RE: Error 5081 - Rawze - 12-13-2024
RE: Error 5081 - Kolczyk - 12-13-2024,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.