| Copying the program out of your ecm ... |
| 09-03-2025, (Subject: Copying the program out of your ecm ... ) Post: #12 | |||
| |||
| Demandate Good afternoon 2018 x15 cm2350, I have the ecm side covered thanks to this forum. I have the cans off and ready to hollow out. To clarify just for the sake of it. I completely gut the cans from front to back on the inside correct? Is there anything I need to watch for that needs to be left in place? ie the outlet where the nox sensor port, the excess particulate sensor port, and inner shroud for the outlet temp sensor? Also taking exhaust bellows from manifold to egr cooler in to have a 1/4 stainless plug welded in. As for the butterfly valve just getting the flap off enough or more? | |||
| « Next Oldest | Next Newest » |
| Messages In This Thread |
Copying the program out of your ecm ... - Rawze - 09-06-2022, RE: Copying the program out of your ecm ... - SquareOne - 09-06-2022, RE: Copying the program out of your ecm ... - RollinCoal - 09-08-2022, RE: Copying the program out of your ecm ... - scott441974 - 10-16-2024, RE: Copying the program out of your ecm ... - tree98 - 09-08-2022, RE: Copying the program out of your ecm ... - SquareOne - 09-09-2022, RE: Copying the program out of your ecm ... - BBBm3 - 09-11-2022, RE: Copying the program out of your ecm ... - Elpidiosilva - 01-29-2024, RE: Copying the program out of your ecm ... - Lunchtime92 - 10-17-2024, RE: Copying the program out of your ecm ... - wadeclaiborne - 11-08-2024, RE: Copying the program out of your ecm ... - HAULNTX - 11-20-2024, Demandate - Kw9006nz - 09-03-2025 RE: Copying the program out of your ecm ... - Kw9006nz - 09-03-2025, RE: Copying the program out of your ecm ... - Rawze - 09-03-2025, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.