Resetting ac actuator on a 2010 lonestar |
08-09-2020, (Subject: Resetting ac actuator on a 2010 lonestar ) Post: #3 | |||
| |||
RE: Resetting ac actuator on a 2010 lonestar 2010 is breakpoint for the AC system. If built in 2010 or later you might need this procedure. 1. Turn the ignition to the on position 2. Turn the fan speed to any speed (1-7) 3. Set HVAC selector to Defrost Mode 4. Remove the fuse box cover and remove the 5 Amp fuse from Battery to HVAC Control Head (ProStar position is F1-B) 5. Wait approximately 30 seconds then reinstall the fuse 6. You should hear the doors recalibrate by moving from one extreme position to the other ◦ Do not operate the control head during the recalibration 7. Start vehicle and check for correct operation of all modes and temperature | |||
|
« Next Oldest | Next Newest » |
Messages In This Thread |
Resetting ac actuator on a 2010 lonestar - Zoomsplat - 08-07-2020, RE: Resetting ac actuator on a 2010 lonestar - Nilao - 08-08-2020, RE: Resetting ac actuator on a 2010 lonestar - DVT873 - 08-09-2020 |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.