High oil pressure |
04-14-2021, (Subject: High oil pressure ) Post: #3 | |||
| |||
RE: High oil pressure Dimes were fine, sensor was fine. Problem was the bore for the pressure relief valve. It looked as if someone had maybe dropped it at one point. I could see where the valve was getting stuck between both ends of the barbell...just enough to keep it from opening under spring pressure. When I did the dimes, I didn't notice it but I sure did when I tore it down. Cleaned up the burr and reassembled it, putting it back in now. Hoping this works ok this time around, my old pump looked a bit rough when I took it apart for comparison. User's Signature: 2010 T2000, CM871, 13spd, 977k, tanker yanker Overhauled @ 927k | |||
|
« Next Oldest | Next Newest » |
Messages In This Thread |
High oil pressure - dhirocz - 04-13-2021, RE: High oil pressure - Rawze - 04-14-2021, RE: High oil pressure - dhirocz - 04-14-2021 |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.