2015 CM2350 Water Pump

[SquareOne]

(12-01-2022 )Hermjeji Wrote:  ...Just as an FYI - you don't have to pull the manifold - it was just the o-ring in there, you can shimmy it out pretty easily. About 1 hour of total work.

So here we are a year later, and I'm seeing seepage from the same place as Hermjeji's pic in the earlier post from last year. So, just to be clear, you were able to replace that O-ring at that point without removing the manifold? Seems like the O-ring at that location is recessed into the manifold which would require the manifold to move forward (or the pipe backward) in order to gain access...

It's been a few months since Hermjeji has been on here, but does anyone else have experience with this procedure? Be nice to be able to replace without removing the entire manifold...