Design change woes-differential episode.

[Mrkentee]

Cursed be manufacturers and their cost cutting schemes.
The old differential was fully rounded on the side. This new one has some metal cut off, and it’s a straight edge for that little section.
Well, guess what. My sealer didn’t quite cover it with that in mind, and I now have a drip. Which means it has to come out again, be cleaned up and resealed. If I did this regularly I might have noticed.
Love it!

[Rawze]

Somehow, that does not surprise me.

What I re-did my own rear ends, I had to machine a set of custom input shaft yokes on my lathe, as mine were no longer available.