Threaded Mode | Linear Mode

Ricky

So I was off for like six weeks and when I started back to work the truck started acting up. It was showing actuator code, it went into limp mode once and lost power a few times pulling. The turbo and actuator were both replaced August 2017 so it's done well. I was looking around and I thought I saw on here that Jerry was getting turbos from HD Turbo but I might be mistaken. But anyway, has anyone experienced them and if so how were they? Also are there anyone else that I can check out? They are doing a sale on mine with the actuator for 2649.00 and a 250 core on the actuator.
I have been running some short loads because work is busy and I really need the money since I was out for so long. If I keep the boost low I haven't had an issue in two days but I'm just trying to prepare. I haven't pulled the actuator but I pulled the intake pipe and the charge air pipe and I don't have any oil and the wheel is tight. I think it might have carboned up because I started it every few days. Sensors have all been pulled and looked like new.
Truck is a 2008 Prostar with 871, built by Allison in February 2021 and tuned at the same time and only has just over 350,000 on the build.

marek4792

Their turbos work good, but for whatever reason some of them do not hold oil. Mind you OEM remans do suffer the same issue..