Cm2250 drinking coolant

[Tamip]

(05-21-2018 )Waterloo Wrote:  

(05-21-2018 )Tamip Wrote:  Who should I get parts from that's comparable to Cummins?

Cummins. Throw that aftermarket crap in there and you will be doing this again in under two years. And who is doing the work? Do you know if they know how to rebuild a Cummins motor? The dealership I had mine rebuilt at, with Cummins certified techs, did a crap job. Bearings were shot, installed wrong parts, total nightmare! Two years to the day, liner fretted, head shot, etc.

Don’t be stupid like myself, good luck.

And buy a NEW head, remans tend to fail in short order. Make sure they cut the block too, .014 on the liner heights!

Thats pretty much was what I was thinking. I was planning on using oem but was curious if anyone had used aftermarket stuff. Just wish this stuff wasn't so damn expensive.