Threaded Mode | Linear Mode

shawnkw · 03-17-2019, **(Subject: 10 speed ??? )**

2011 kw 10 speed I had my clutch brake adjusted in Pennsylvania while I was up that way. Now I’m back in Florida and during my post trip I noticed this cable/linkage hanging down just in front of my bell housing. I’m guessing this is why my clutch brake isn’t working again. It grinds when I initially put it into gear. Any help would be appreciated. I’m in Jacksonville Florida. Thank you

Shawn

shawnkw · 03-17-2019, **(Subject: 10 speed ??? )**

Also would like to point out that you can see where it was going through a grommet through a plate on the front of the bell housing. Yes I’m new here and haven’t made many post but have lurked for a while.

Thank you

Rockhwy · 03-17-2019, **(Subject: 10 speed ??? )**

That is the remote grease line to throw out bearing they took it off or it broke from when they took inspection cover off to adjust clutch, that's what I think it looks like to me anyway

shawnkw · 03-17-2019, **(Subject: 10 speed ??? )**

10-4 thank you driver. It was dark by the time I got back to it. I’ll take off the inspection cover tomorrow and take a better look.

Thank you

hosetrucking · 03-19-2019, **(Subject: 10 speed ??? )**

I thought the same thing as what rock Highway said. It looks like it's the remote Grease hose for your throwout bearing