Automated Eaton 10 speed shifting weird

[mikealike]

(07-20-2019 )Satch Wrote:  As of now, I get code 88. The other day I had a transmission fault code at the traffic light. It wouldn't do anything until I disconnected batteries and waited a few minutes. I believe they were 17 and 34. I'll double-check.

She drove fine today. But you kinda have to drive it to line a 13 speed. One has to let off the throttle during gear switching. Not let rpm go lower than 1200to 1300.

Does the XY shifter need to be calibrated after install?

normally when I've replaced the XY shifter I follow the details from the install card and it should be fine. Now I had one that's a 3rd gen shifter on the 1 gen setup and it needed to be calibrated. Called my buddy from Rush and he had it rolling after a couple of minutes with the computer hooked up