Oil leak, between flywheel housing and block |
03-05-2021, (Subject: Oil leak, between flywheel housing and block ) Post: #14 | |||
| |||
RE: Oil leak, between flywheel housing and block Scotch pads will absolutely get them ready to refit, no problems. I prefer to sand them as most of them have serious fretting. It leaves a nice, uniform finish without the excessive time and material loss of having the housings machined. I use the same practice for all flat gasket surfaces of exh manifolds, front and rear housings, thermostat housings, intake manifolds, etc. Consider it a gentlemanly alternative to those 2" buff wheels people like to use. | |||
|
« Next Oldest | Next Newest » |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.