Windshield washer fluid line failed... Have question.

[74bassman]

My pump stop working. I replace the pump today, but didnt fix it. I check for continuity no power to the pump. I check for power at the fuse, and still no power. This tells me the switch might be bad. So how do i acess the switch on the steering wheel?

[slowpoke]

when mine stop working i put a push button momentary switch in, on left side of lower dash only had to run 1 wire to pump because i had pos voltage at pump all the time so my switch completes the ground,on mine anyway. don't know if there all like that.

[Rawze]

(07-04-2018 )74bassman Wrote:  My pump stop working. I replace the pump today, but didnt fix it. I check for continuity no power to the pump. I check for power at the fuse, and still no power. This tells me the switch might be bad. So how do i acess the switch on the steering wheel?

What make/model/year truck?

If it is a prostar you should look at this as a possible cause too ...
http://rawze.com/forums/showthread.php?t...1#pid12861

[74bassman]

I did look this, and I will check those fuses.

[74bassman]

The truck is 2010 prostar

[Rawze]

(07-04-2018 )74bassman Wrote:  ...
So how do i acess the switch on the steering wheel?

On mine, I just pop the center part off (the city horn), then you get access to the screws to take the rest apart.

[74bassman]

I replace the turn signal, and wiper pump switch. Still nothing. I check for volts at the fuse, and it appears that I'm not getting any power at the fuse.
I can see a gray wire, and 2 red (pink). 1 pink wire comes from the fuse in front of it. Would the grey wire becoming from the switch or the other red wire?

[Mr Hagg]

Im betting that maybe one of the power feed relays is not sending power to fuse panel...

[74bassman]

How can i check that