CM2350 X101 X15 - Turbo Actuator

[Hermjeji]

(12-15-2021 )Rawze Wrote:  if it has not failed, is operating when you drive to them, the stealers$it will not likely warranty anything and it will cost you an arm and a leg to have them look at it. They are not likely going to do as you ask with any details either.. I would not trust them enough to throw a wrench at em these days... just my opinion.


just a thought.

The code you mention is a pretty common one. It is essentially saying that the turbo did not respond to the ecm fast enough (wiring harness issues, battery low, or voltage spikes during cranking, key-switch going directly from the off position to the crank position too quickly , driver not waiting those 5 or 6 seconds for the system to come up, etc. can cause it.

- But it is not normal to get a CEL over it while driving the truck.

This continues to be an intermittent issue on the X15, The actuator doesn't respond and sometimes won't allow the truck to start. I'll wiggle the connector on the actuator and it will start fine. Once operating, truck doesn't throw codes, but on startup it does once a week or so. I think it's a harness issue, or connection issue, is there anything i can do to make it more robust, and what should I be expecting in terms of resistance to check for any harness issues? This is what I gathered from quickserve: