ISX CM2250 in a Freightshaker

[Ironwagons]

(04-05-2023 )Rawze Wrote:  

(04-05-2023 )Ironwagons Wrote:  The Cummins stock exhaust manifold has the outlet on one end to go into the EGR system. I have metal coolant tubes from the water pump to the rear of the engine. If I purchase the opposite end without the outlet will the bolt patterns line up with the end that had the outlet? Thanks in advance

It will fit, ... but the issue is that you would also need to cut the bung out of the old piece and weld it into the new one + drill so that the exhaust manifold pressure sensor can operate correctly again.

here is a pic of one that someone sells with the bung already in it...
http://rawze.com/forums/showthread.php?t...5#pid71695

Thanks much!