X15 connecting rods replacement?

[Rawze]

That injector ran hotter than the rest, most likely for the same reasons that its being inframed in half the expected time it is supposed to be.

= Big power + low rpm, high torque abuse from bad driving habits, ... and/or bad delete programming... Take your pick of such ...

An abuse of the engine that defeated its expected longevity, in one way or the other.

====================
Lets put it this way ...
Do you think that if I owned it, that it would have only lasted 530k miles before a liner danced in the block like that?.

I Don't know about anyone else, but I actually want to make a long term profit off of my equipment,.. and not drop $25,000+ into it 2x more often than it should be... I don't care how much slower it has to go up the hills!. hence, the first da$mn thing that I would have done after purchase would have been to RE-GEAR THE REAR ENDS CORRECTLY vs. the freight/weights I was hauling .. AND TURNED THE DAMN TORQUE DOWN TO ABOUT 1760 OR SO MAX!. And any PTO operations would have been re-geared so that the engine ran 1500-1600RPM to operate that too!.